Welcome to your new Jawbone® JAMBOXTM, the world’s first intelligent speaker and speakerphone. JAMBOX delivers killer wireless audio without the hassle of cables and docking stations. JAMBOX also gives you the freedom to share music, movies, games and calls whenever you want. It’s the perfect companion to any phone, mp3 player, tablet or laptop. Whatever your jam may be, amp it up with JAMBOX. Please read these safety warnings and cautions carefully to ensure your personal safety and prevent property damage.

Plug JAMBOX into your wall charger or computer via micro USB cable. It takes 1.5 hours to give your JAMBOX an 80% charge. A full charge takes 2.5 hours. Connect to JAMBOX™ wirelessly via Bluetooth® or via 3.5mm stereo input. When using JAMBOX as a speakerphone, please note that JAMBOX’s built-in microphone only works while connected via Bluetooth. Your JAMBOX can wirelessly stream audio from any Bluetooth device within 33 feet. Just follow the steps on the next page.

Jawbone® JAMBOX™ is resting on its base and facing forward. When connected wirelessly via Bluetooth®, it’s best to turn the volume on your phone/device fully up and then use the PLUS and MINUS BUTTONS on your JAMBOX. When connected via 3.5mm stereo input, your phone/device may distort the audio signal if turned up too loud. Turn down the volume on your phone/device before adjusting the volume on your JAMBOX. Jawbone JAMBOX tells you important information like remaining battery life and caller ID for incoming calls. Press the TALK BUTTON to hear remaining battery life. When your battery is low, you will hear automatic battery status alerts. Incoming and outgoing calls will always take precedence over audio playback. Audio content via 3.5mm stereo input will override wireless audio via Bluetooth. Your JAMBOX™ can be used as a wireless speakerphone. Just speak in the direction of the front grill. The built-in microphone only works when connected via Bluetooth®.
Download or view Jawbone Jambox Manual

Your band takes approximately one hour to fully charge. Connect the charging cable to your band by aligning the pins on the charger with the band. A magnet will hold the charger in place. Insert the charging cable into the USB drive on your computer or a standard USB wall adapter. Icons on the face of the band will light up and pulse while the band is charging. When the band is fully charged the icons will stop pulsing and the runner icon will glow solid. The band should be worn on your non-dominant wrist. Place the band on your wrist and rest your wrist on a flat surface. Thread the strap through the loop and tighten the strap so that all of the sensors are touching your skin. The band should be snug, but not tight. Use your finger to hold the loop in place and fold the strap over.
Note where the clasp lands. Remove the band and adjust the buckle by sliding it in place. Put the band back on and insert the clasp into the buckle. You must be wearing your band to activate it and change modes. Rapidly tap the top band surface until it wakes. The runner icon will glow to indicate you are in Awake mode. A moon icon will glow to indicate you are in Sleep mode. Touch and hold the surface of the band to switch modes, the band will vibrate and the runner or moon icon, depending on which mode you are in, will light up. Set your band to Awake mode to track your daytime activity and steps.